Skip to content
Hot eventDeveloping

Claude Code Takes an Analog Synthesizer From Prompt to Working PCB

1 reports1 reporting sourcesUpdated 7 h ago

Start here

AI digest

An author tested whether Claude Code running Opus 5.5 could design an MCU-controlled analog synthesizer end to end, starting from a JLCPCB free-parts list and ending with a routed four-layer PCB, firmware and a bring-up plan. The design took 19 hours from first prompt to order, with most of that time spent on unattended Freerouting runs; the author said he had to intervene most on PCB layout and floorplanning. After the boards arrived, automated bring-up using audio loopback and an oscilloscope showed close agreement between the ngspice simulations and the real hardware. The only hardware fix needed was a hand-soldered solder bridge on the MCU.

Generated from reports · updated 7 h ago

Report timeline

Follow the reports to see the event from different sides.

November 16
  1. Hacker News · AI
    Agentic AI Designs an Analog Synthesizer: A Hands-On Test of Claude Code on Mixed-Signal PCB Work

    The author tested whether Claude Code with Opus 5.5 could design an MCU-controlled analog synthesizer end to end, from a JLCPCB free-parts list to a routed four-layer PCB, firmware and bring-up plan. The design took 19 hours from first prompt to order, with most time spent on unattended Freerouting runs, and the author had to intervene most on PCB layout and floorplanning. After the boards arrived, automated bring-up via audio loopback and an oscilloscope showed excellent agreement between the ngspice simulations and the real hardware, with the only hardware fix being a hand-soldered solder bridge on the MCU.

Heat for this event

Current, comparable range
8
Peak, comparable range
10November 16 10:00
Change in 24 hours
–

The trend compares the same participants over hours observed continuously, so its range can be narrower than the current heat count. Hover or tap the chart for hourly heat; the arrow keys move through it.